Materials used for insulation

  1. Rubber
  2. Vulcanized Indian Rubber
  3. Impregnated paper
  4. Varnished Cambric
  5. PVC

Rubber.


Rubber may be obtained from milky sap of tropical trees or it may be produced from oil products. It has relative permittivity varying between 2 and 3, dielectric strength is about 30 kV/mm and resistivity of insulation is 1017cm. Although pure rubber has reasonably high insulating properties, it suffers from some major drawbacks viz., readily absorbs moisture, maximum safe temperature is low (about 38ºC), soft and liable to damage due to rough handling and ages when exposed to light. Therefore, pure rubber cannot be used as an insulating material. Top.


Vulcanised India Rubber (V.I.R.).

It is prepared by mixing pure rubber with mineral matter such as zine oxide, red lead etc., and 3 to 5% of sulphur. The compound so formed is rolled into thin sheets and cut into strips. The rubber compound is then applied to the conductor and is heated to a temperature of about 150ºC. The whole process is called vulcanization and the product obtained is known as vulcanised India rubber.

Vulcanized India rubber has greater mechanical strength, durability and wear resistant property than pure rubber. Its main drawback is that sulphur reacts very quickly with copper and for this reason, cables using VIR insulation have tinned copper conductor. The VIR insulation is generally used for low and moderate voltage cables. Top.


Impregnated paper.

It consists of chemically pulped paper made from wood chippings and impregnated with some compound such as paraffinic or napthenic material. This type of insulation has almost superseded the rubber insulation. It is because it has the advantages of low cost, low capacitance, high dielectric strength and high insulation resistance. The only disadvantage is that paper is hygroscopic and even if it is impregnated with suitable compound, it absorbs moisture and thus lowers the insulation resistance of the cable. For this reason, paper insulated cables are alwaysprovided with some protective covering and are never left unsealed. If it is required to be left unused on the site during laying, its ends are temporarily covered with wax or tar.
Since the paper insulated cables have the tendency to absorb moisture, they are used where the cable route has a *few joints. For instance, they can be profitably used for distribution at low voltages in congested areas where the joints are generally provided only at the terminal apparatus. However, for smaller installations, where the lenghts are small and joints are required at a number of places, VIR cables will be cheaper and durable than paper insulated cables. Top.


Varnished cambric.

It is a cotton cloth impregnated and coated with varnish. This type of insulation is also known as empire tape. The cambric is lapped on to the conductor in the form of a tape and its surfaces are coated with petroleum jelly compound to allow for the sliding of one turn over another as the cable is bent. As the varnished cambric is hygroscopic, therefore, such cables are always provided with metallic sheath. Its dielectric strength is about 4 kV/mm and permittivity is 2.5 to 3.8. Top.


Polyvinyl chloride (PVC).

This insulating material is a synthetic compound. It is obtained from the polymerisation of acetylene and is in the form of white powder. For obtaining this material as a cable insulation, it is compounded with certain materials known as plasticizers which are liquids with high boiling point. The plasticizer forms a gell and renders the material plastic over the desired range of temperature.
Polyvinyl chloride has high insulation resistance, good dielectric strength and mechanical toughness over a wide range of temperatures. It is inert to oxygen and almost inert to many alkalies and acids. Therefore, this type of insulation is preferred over VIR in extreme enviormental conditions such as in cement factory or chemical factory. As the mechanical properties (i.e., elasticity etc.) of PVC are not so good as those of rubber, therefore, PVC insulated cables are generally used for low and medium domestic lights and power installations. Top.

16 thoughts on “Materials used for insulation

  1. Pingback: Underground cables « iiteeeestudents

  2. Pingback: String Effeciency and methods to improve String Effeciency « iiteeeestudents

  3. Preventing Earthquake Failure of Structural Precast Concrete Components.
    Nowadays there is a surfeit of such service providers and almost all of them promises to deliver very good services to the
    customers. Any good set of plans should include at least dimensionally accurate three-view drawings of the entire structure, similar drawings for
    every detail part unless it is clearly shown on the main drawings, three dimensional diagrams for all main and sub-assemblies,
    full material specifications, quantity and exact cut dimensions for every part and a list of
    all bought-out hardware such as fasteners and brackets.

  4. Most land based casinos do this kind of trick to attract passersby to try online casino
    games like slots when they hear cheers from players who are winning.
    Drive to the scene, and then talk to the officer waiting
    by the stairs. It’s for this reason that I’ve made my
    miscellaneous section a 3 out of 5.

  5. Die geilen Frauen hier haben echt dicke Titten und sie lieben es, wenn du dein Schwanz zwischen die Möpse schiebst und dann auf ihre schönen Brüste spritzen kannst.

  6. This is the right web site for anybody who wishes to understand this topic.
    You understand so much its almost hard to argue with you (not that I really
    would want to…HaHa). You definitely put a brand new
    spin on a topic that’s been written about for years.

    Wonderful stuff, just excellent!

  7. I like what you guys tend to be up too. Such
    clever work and exposure! Keep up the very good works guys I’ve added you guys to my own blogroll.

  8. You can certainly see your expertise within the work you write.
    The arena hopes for more passionate writers like you who aren’t afraid to mention how they believe.
    At all times follow your heart.

  9. The number one loophole that you should look for is how to track hot numbers and cold numbers.
    If you want to succeed, you have to put in more effort by buying more lottery tickets.
    The documentary has received positive reviews and will be released
    on DVD sometime in the future. For Mega Millions, unclaimed cash prizes are returned back to
    member states to be spent on various government programs.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s